ZyXEL Communications UAG Series - Chapter 41 AAA Server; 41.1 AAA Server Overview; 41.2 Authentication Server Command Summary; 41.2.1 ad-server Commands

Chapter 33 System Remote Management
UAG CLI Reference Guide
215
33.8.3 SNMP Commands
The following table describes the commands available for SNMP. You must use the configure
terminal
command to enter the configuration mode before you can use these commands.
33.8.4 SNMP Commands Examples
The following command sets a service control rule that allowed the computers with the IP
addresses matching the specified address object to access the specified zone using SNMP service.
Table 124 Command Summary: SNMP
COMMAND DESCRIPTION
[no] snmp-server Allows SNMP access to the UAG. The no command disables
SNMP access to the UAG.
[no] snmp-server community community_string
{ro|rw}
Enters up to 64 characters to set the password for read-only
(ro) or read-write (rw) access. The
no command resets the
password for read-only (
ro) or read-write (rw) access to the
default.
[no] snmp-server contact description Sets the contact information (of up to 60 characters) for the
person in charge of the UAG. The
no command removes the
contact information for the person in charge of the UAG.
[no] snmp-server enable {informs|traps} Enables all SNMP notifications (informs or traps). The
no
command disables all SNMP notifications (informs or traps).
[no] snmp-server host {w.x.y.z}
[community_string]
Sets the IPv4 address of the host that receives the SNMP
notifications. The
no command removes the host that receives
the SNMP notifications.
[no] snmp-server location description Sets the geographic location (of up to 60 characters) for the
UAG. The
no command removes the geographic location for the
UAG.
[no] snmp-server port <1..65535> Sets the SNMP service port number. The
no command resets
the SNMP service port number to the factory default (
161).
snmp-server rule {rule_number|append|insert
rule_number} access-group {ALL|address_object}
zone {ALL|zone_object} action {accept|deny}
Sets a service control rule for SNMP service.
address_object: The name of the IP address (group) object.
You may use 1-31 alphanumeric characters, underscores(
_), or
dashes (-), but the first character cannot be a number. This
value is case-sensitive.
zone_object: The name of the zone. Use up to 31 characters
(a-zA-Z0-9_-). The name cannot start with a number. This value
is case-sensitive.
The UAG uses pre-defined zone names like DMZ, LAN1, LAN2,
SSL VPN, IPSec VPN, and WAN.
snmp-server rule move rule_number to rule_number Changes the index number of a service control rule.
no snmp-server rule rule_number Deletes a service control rule for SNMP service.
show snmp status Displays SNMP Settings.
Router# configure terminal
Router(config)# snmp-server rule 11 access-group Example zone WAN action accept