ZyXEL Communications UAG Series - Ethernet Interfaces; Saving Configuration Changes; Logging out

Chapter 1 Command Line Interface
UAG CLI Reference Guide
33
1.8 Ethernet Interfaces
How you specify an Ethernet interface depends on the UAG model.
• The UAG 715 uses a name such as wan1, wan2, lan1, lan2, or dmz.
1.9 Saving Configuration Changes
Use the write command to save the current configuration to the UAG.
Note: Always save the changes before you log out after each management session. All
unsaved changes will be lost after the system restarts.
1.10 Logging Out
Enter the exit or end command in configure mode to go to privilege mode.
Enter the
exit command in user mode or privilege mode to log out of the CLI.
week-day sequence, i.e.
1=first,2=second
1 1-4
xauth method 1-31 alphanumeric or _-
xauth password 1-31 alphanumeric or ;|`~!@#$%^&*()_+\{}':,./<>=-
mac address 0-12 (even
number)
hexadecimal
for example: aa aabbcc aabbccddeeff
Table 3 Input-Value Formats for Strings in CLI Commands (continued)
TAG # VALUES LEGAL VALUES