ZyXEL Communications UAG Series - Link Sticking Command Example

Chapter 7 Trunks
UAG CLI Reference Guide
79
mode before you can use these commands. See Table 30 on page 76 for details about the values
you can input with these commands.
7.8 Link Sticking Command Example
This example shows how to activate link sticking and set the timeout to 600 seconds (ten minutes).
Table 32 ip load-balancing link-sticking Commands Summary
COMMAND DESCRIPTION
[no] ip load-balancing link-sticking activate Turns link sticking on or off.
[no] ip load-balancing link-sticking timeout
timeout
Sets for how many seconds (30-3600) the UAG sends all of each
local computer’s traffic through one WAN interface.
show ip load-balancing link-sticking status Displays the current link sticking settings.
Router(config)# ip load-balancing link-sticking activate
Router(config)# ip load-balancing link-sticking timeout 600
Router(config)# show ip load-balancing link-sticking status
active : yes
timeout : 300