ZyXEL Communications UAG Series - Page 227

Chapter 34 File Manager
UAG CLI Reference Guide
227
Note: You only need to use the atuk or atur command if the recovery image is damaged.
Figure 31 atuk Command for Restoring the Recovery Image
4 Enter Y and wait for the “Starting XMODEM upload” message before activating XMODEM upload on
your terminal.
Figure 32 Starting Xmodem Upload
5 This is an example Xmodem configuration upload using HyperTerminal. Click Transfer, then Send
File to display the following screen.
Figure 33 Example Xmodem Upload
6 Wait for about three and a half minutes for the Xmodem upload to finish.
Figure 34 Recovery Image Upload Complete
> atuk
This command is for restoring the "recovery image" (xxx.ri).
Use This command only when
1) the console displays "Invalid Recovery Image" or
2) the console freezes at "Press any key to enter debug mode within 3 seconds"
for more than one minute.
Note:
Please exit this command immediately if you do not need to restore the
"recovery image".
Do you want to start the recovery process (Y/N)? (default N)
Do you want to start the recovery process (Y/N)? (default N)
Starting XMODEM upload (CRC mode) ....
C
Type the firmware file's
location, or click Browse to
search for it.
Choose the 1K Xmodem
protocol.
Then click Send.
Total 1067264 bytes received.
programming .......................................................................
....................................................................................
....................................................................................
....................................................................................
....................................................................................
....................................................................................
OK
>