ZyXEL Communications UAG Series - Page 37

Chapter 2 User and Privilege Modes
UAG CLI Reference Guide
37
debug eps Endpoint security debug commands
debug force-auth (*) Authentication policy debug commands
debug gui (*) Web Configurator related debug
commands
debug hardware (*) Hardware debug commands
debug interface Interface debug commands
debug interface ifconfig
[interface]
Shows system interfaces detail > ifconfig [interface]
debug interface-group Port grouping debug commands
debug ip dns DNS debug commands
debug ip virtual-server Virtual Server (NAT) debug commands
debug ipsec IPSec VPN debug commands
debug logging System logging debug commands
debug manufacture Manufacturing related debug commands
debug myzyxel server (*) Myzyxel.com debug commands
debug network arpignore (*) Enable/Display the ignoring of ARP
responses for interfaces which don't own
the IP address
cat /proc/sys/net/ipv4/conf/*/
arp_ignore
debug no myzyxel server (*) Set the myZyXEL.com registration/update
server to the official site
debug policy-route (*) Policy route debug command
debug reset content-filter
profiling
Content Filtering debug commands
debug service-register Service registration debug command
debug show content-filter server Category-based content filtering debug
command
debug show myzyxel server status Myzyxel.com debug commands
debug show ipset Lists the UAG‘s received cards
debug show myzyxel server status Myzyxel.com debug commands
debug sslvpn SSL VPN debug commands
debug [cmdexec|corefile|ip
|kernel|mac-id-
rewrite|observer|switch
|system|zyinetpkt|zysh-ipt-op]
(*)
ZLD internal debug commands
debug update server (*) Update server debug command
Table 5 Debug Commands (continued)
COMMAND SYNTAX DESCRIPTION LINUX COMMAND EQUIVALENT