Chapter 8 Home Networking
VMG8825-B Series User’s Guide
129
3 Click Apply to save your settings.
Figure 57 Network Setting > Home Networking > LAN Setup
The following table describes the fields in this screen.
Table 31 Network Setting > Home Networking > LAN Setup
LABEL DESCRIPTION
Interface Group
Group Name Select the interface group name for which you want to configure LAN settings. See Chapter 15
on page 192 for how to create a new interface group.
LAN IP Setup
IPAddress Enter the LAN IPv4 IP address you want to assign to your VMG in dotted decimal notation, for
example, 192.168.1.1 (factory default).
Subnet Mask Type the subnet mask of your network in dotted decimal notation, for example 255.255.255.0
(factory default). Your VMG automatically computes the subnet mask based on the IP Address
you enter, so do not change this field unless you are instructed to do so.
IGMP Snooping
Active Select Enable to activate IGMP Snooping. This allows the VMG to passively learn memberships in
multicast groups. Otherwise, select Disable to deactivate it.
To Next Page
Loading...
