Chapter 35 Remote Management
VMG8825-B Series User’s Guide
284
35.3 The Trust Domain Screen
Use this screen to view a list of public IP addresses which are allowed to access the VMG through the
services configured in the Maintenance > Remote Management screen. Click Maintenance > Remote
Management > Turst Domain to open the following screen.
Note: If this list is empty, all public IP addresses can access the VMG from the WAN through
the specified services.
Figure 170 Maintenance > Remote Management > Trust Domain
The following table describes the fields on this screen.
35.4 The Add Trust Domain Screen
Use this screen to configure a public IP address which is allowed to access the VMG. Click the Add Trust
Domain button in the Maintenance > Remote Management > Turst Domain screen to open the following
screen.
Trust Domain Select the Enable check box for the corresponding services that you want to allow access to the
VMG from the trusted hosts configured in the Maintenance > Remote MGMT > Trust Domain
screen.
If you only want certain WAN connections to have access to the VMG using the corresponding
services, then clear WAN, select Trust Domain and configure the allowed IP address(es) in the
Trust Domain screen.
Port You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Apply Click Apply to save your changes back to the VMG.
Cancel Click Cancel to restore your previously saved settings.
Table 135 Maintenance > Remote Management > MGMT Services (continued)
LABEL DESCRIPTION
Table 136 Maintenance > Remote Management > Trust Domain
LABEL DESCRIPTION
Add Trust
Domain
Click this to add a trusted host IP address.
IP Address This field shows a trusted host IP address.
Delete Click the Delete icon to remove the trust IP address.
To Next Page
Loading...
