Chapter 15 Interface Grouping
VMG8825-B Series User’s Guide
194
Figure 108 Interface Group Configuration
The following table describes the fields in this screen.
Table 77 Interface Group Configuration
LABEL DESCRIPTION
Group Name Enter a name to identify this group. You can enter up to 30 characters. You can use letters,
numbers, hyphens (-) and underscores (_). Spaces are not allowed.
WAN Interfaces
used in the
grouping
Select the WAN interface this group uses. The group can have up to one PTM interface, up to
one ATM interface, up to one ETH interface, and and up to one WWAN interface.
Select None to not add a WAN interface to this group.
Selected LAN
Interfaces
Available LAN
Interfaces
Select one or more LAN interfaces (Ethernet LAN, HPNA or wireless LAN) in the Available LAN
Interfaces list and use the left arrow to move them to the Selected LAN Interfaces list to add the
interfaces to this group.
To remove a LAN or wireless LAN interface from the Selected LAN Interfaces, use the right-facing
arrow.
Automatically
Add Clients With
the following
DHCP Vendor
IDs
Click Add to identify LAN hosts to add to the interface group by criteria such as the type of the
hardware or firmware. See Section 15.2.2 on page 195 for more information.
# This shows the index number of the rule.
To Next Page
Loading...
