Chapter 3 Hardware Overview
GS1910/XGS1910 Series User’s Guide
19
1 Insert the transceiver into the slot with the exposed section of PCB board facing
down.
Figure 14 Transceiver Installation Example
2 Press the transceiver firmly until it clicks into place.
3 The Switch automatically detects the installed transceiver. Check the LEDs to
verify that it is functioning properly.
Figure 15 Installed Transceiver
3.1.3.2 Transceiver Removal
Use the following steps to remove a transceiver (SFP or SFP+ module).
1 Open the transceiver’s latch (latch styles vary).
Figure 16 Opening the Transceiver’s Latch Example
To Next Page
Loading...
