Chapter 5 Tutorials
GS1910/XGS1910 Series User’s Guide
40
In the example network, configure 2 as the port VID on port 1 so that any untagged frames
received on that port get sent to VLAN 2.
Figure 29 Port VID Example
1 Click Configuration > VLANs > Ports in the navigation panel.
2 Set Port VLAN Mode to Specific and enter 2 in the Port VLAN ID field for port 1.
3 To ensure that VLAN-unaware devices (such as computers and hubs) can receive frames properly,
you can either select Untag_all in the TX Tag field to set the Switch to remove any VLAN tags
before sending or leave the TX Tag field at Untag_pvid to have the Switch remove a frame’s VLAN
tag when the frame’s VLAN ID is the same as the PVID of the port on which the frame is
transmitted.
4 click Save to save your changes back to the Switch.
To Next Page
Loading...
