ZyXEL Communications XGS3700 Series - Page 321

Chapter 38 VRRP
GS3700/XGS3700 Series User’s Guide
321
You need to configure the VRRP Configuration screen for virtual router VR2 on each switch, while
keeping the VRRP configuration in example 1 for virtual router VR1 (refer to Section 38.4.2 on
page 320). Configure the VRRP parameters on the switches as shown in the figures below.
Figure 211 VRRP Example 2: VRRP Parameter Settings for VR2 on Switch A
Figure 212 VRRP Example 2: VRRP Parameter Settings for VR2 on Switch B
After configuring and saving the VRRP configuration, the VRRP Status screens for both switches
are shown next.
Figure 213 VRRP Example 2: VRRP Status on Switch A
Figure 214 VRRP Example 2: VRRP Status on Switch B
EXAMPLE
EXAMPLE
EXAMPLE
EXAMPLE