Chapter 3 Hardware Panels
XS1920 Series User’s Guide
27
3 The Switch automatically detects the installed transceiver. Check the LEDs to verify that it is
functioning properly.
4 Close the transceiver’s latch (latch styles vary).
5 Connect the fiber optic cables to the transceiver.
Figure 8 Transceiver Installation Example
Figure 9 Connecting the Fiber Optic Cables
3.1.2.2 Transceiver Removal
Use the following steps to remove a mini-GBIC transceiver (SFP+ module).
1 Remove the fiber optic cables from the transceiver.
2 Open the transceiver’s latch (latch styles vary).
3 Pull the transceiver out of the slot.
Figure 10 Removing the Fiber Optic Cables
Figure 11 Opening the Transceiver’s Latch Example
Figure 12 Transceiver Removal Example
To Next Page
Loading...
