452/749
How to Setup and Configure Email Logs
This example shows how to set up the e-mail profiles to mail ZyWALL/USG log
messages to the specific destinations. You can also specify which log messages to
e-mail, and where and how often to e-mail them. When the Email Logs is configured,
you will receive logs email report base on customized schedule.
ZyWALL/USG Setup and Configure E-mail Logs
Set Up the ZyWALL/USG Email Logs Setting
1. Go to CONFIGURATION > Log & Report > Log Settings > System Log > Edit > E-mail
Server 1. Select Active. Type the SMTP server name or IP address. In Mail From,
Note: All network IP addresses and subnet masks are used as examples in this
article. Please replace them with your actual network IP addresses and subnet
masks. This example was tested using USG110 (Firmware Version: ZLD 4.25).
To Next Page
Loading...
