ZyXEL Communications ZyWall 110 - How to Configure Site-To-Site Ipsec VPN Where the Peer Has a Dynamic IP Address; Set up the Zywall;Usg Ipsec VPN Tunnel of Corporate Network (HQ)

73/749
www.zyxel.com
How to Configure Site-to-site IPSec VPN Where the Peer has a
Dynamic IP Address
This example shows how to use the VPN Setup Wizard to create a site-to-site VPN
with the Peer has a Dynamic IP Address. The example instructs how to configure
the VPN tunnel between each site. When the VPN tunnel is configured, each site
can be accessed securely.
ZyWALL Site-to-site IPSec VPN with a Dynamic IP Address Peer
Set Up the ZyWALL/USG IPSec VPN Tunnel of Corporate Network
(HQ)
In the ZyWALL/USG, go to CONFIGURATION >Quick Setup > VPN Setup Wizard, use
the VPN Settings wizard to create a VPN rule that can be used with the remote
ZyWALL/USG. Click Next.
Note: All network IP addresses and subnet masks are used as examples in this article.
Please replace them with your actual network IP addresses and subnet masks. This
example was tested using USG310 (Firmware Version: ZLD 4.25).