ZyXEL Communications ZyWall 110 - Set up the Routing on the Zywall;Usg; Test the Result

668/749
www.zyxel.com
Set Up the Routing on the ZyWALL/USG
In the ZyWALL/USG, go to CONFIGURATION > Network > Routing, set Next-Hop
Type to be Interface and set Interface to be the vlan1.
CONFIGURATION > Network > Routing
Test the Result
Check the Interface Statistics, you can see vlan1 Status is up, Tx B/s displays the
transmission speed and Rx B/s displays the reception speed. Port 5 and Port 6 are
configured in the same vlan1 but use different IP addresses.
MONITOR > Interface Status > Interface Statistics