ZyXEL Communications ZyWALL USG-Series - Zywall USG 100; Creating the Address Objects; Creating VPN Gateway

4/8
www.zyxel.com
ZyWALL USG 100
Creating the address objects
Go to Configuration  Object  Address and click the Add button.
Now create a Subnet address that contains the LAN Subnet of the
opposite ZyWALL USG as shown in the picture below:
Creating VPN Gateway
Go to Configuration  VPN  IPSec VPN  VPN Gateway and click the
Add button. You need to make sure the Gateway is enabled. Fill in the
Interface field with the WAN IP of the ZyWALL USG 100. For Peer
Gateway Address you should choose “Static Address” and type in the
remote ZyWALL USG 200 WAN IP or Domain/DDNS hostname. You also
need to type in a Pre-Shared Key of the VPN connection. This key should
match that of the remote ZyWALL USG 200.