ES-2048 User’s Guide
Chapter 22 DiffServ Code Point 167
Figure 74 DiffServ: DSCP Setting
The following table describes the labels in this screen.
Table 48 DiffServ: DSCP Setting
LABEL DESCRIPTION
0 … 63 This is the DSCP classification identification number.
To set the IEEE802.1p priority mapping, select the priority level from the drop-down list box.
Apply Click Apply to save your changes to the switch’s run-time memory. The switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to discard all changes and start configuring the screen again.
To Next Page
Loading...
