ES-2048 User’s Guide
Chapter 36 Multicast VLAN Registration Commands 279
CHAPTER 36
Multicast VLAN Registration
Commands
This chapter shows you how to use Multicast VLAN Registration (mvr) commands.
36.1 Overview
Use the mvr commands in the configuration mode to create and configure multicast VLANs.
Note: If you want to enable IGMP snooping see Section 33.1 on page 249.
36.2 Create Multicast VLAN
Use the following commands in the config-mvr mode to configure a multicast VLAN group.
Syntax:
mvr <vlan-id>
mvr <vlan-id> source-port <port-list>
mvr <vlan-id> receiver-port <port-list>
mvr <vlan-id> inactive
mvr <vlan-id> mode <dynamic|compatible>
mvr <vlan-id> name <name-str>
mvr <vlan-id> tagged <port-list>
mvr <vlan-id> group <name-str> start-address <ip> end-address <ip>
mvr <vlan-id> exit
where
<vlan-id>
= The VLAN ID [1 – 4094].
source-port
<port-list>
= Specifies the MVR source ports which send and receive multicast
traffic.
receiver-port
<port-list>
= Specifies the MVR receiving ports which only receive multicast
traffic.
name <name-str>
= A name to identify the multicast VLAN group.
mode
<dynamic|compati
ble>
= Specifies dynamic (sends IGMP reports to all source ports in the
multicast VLAN) or compatible (does not send IGMP reports).
To Next Page
Loading...
