23
Roaming enable/disable Function No.: 42
You can make EasyGate work even if it is registered to a foreign GSM network.
Setting options:
-Disable -The GSM module logs out of a foreign network and attempts to
register again in within 5 minutes.
-Enable -EasyGate works in any GSM network.
Default setting: Disable
Incoming calls enable Function No.: 43
With this parameter you can reject all incoming calls.
Setting options:
Enable - Incoming calls ring on the telephone line.
Disable - Incoming calls are rejected.
Default setting: Enable
8.3.5. Service Parameters
Hardware version Function No.: -
EasyGate hardware version - for information only (cannot be modified). Must be
used for communication with the manufacturer.
Firmware version Function No.: -
EasyGate firmware version - EasyGate central processor program version. The
manufacturer can issue upgrades to extend functions. To load new firmware into
EasyGate use the Upgrade function. Keep communicating with the manufacturer.
Serial number Function No.: -
EasyGate serial number - for information only (cannot be changed). Must be
used for communication with the manufacturer.
GSM operator lock Function No.: -
Refer to GSM & SIM Parameters.
COM enable Function No.: 50
With this parameter you can enable/disable the serial interface function. You can
disable communication in the operating mode, maintaining the special
programming mode after power up.
Setting options: YES/NO
Default setting: YES