2N IP Force 9151101W - Page 76

Installation manual 2N® IP Force

76 / 118
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
The purpose of the tamper switch is tosignal any unauthorised opening of
the intercom (to prevent a theft, e.g.).It is recommended to use the tamper
switch.
Specifications:
Card reader
Operating frequency: 13.56 MHz
Minimum reading distance: 30 mm above2N
®
IP Forcecover
RFID Reader 9151031is compatible with cards (only card serial number is read):
ISO14443A (Mifare, DESFire)
PicoPass (HID iClass)
FeliCa
ST SR(IX)
2N
®
Mobile Key
RFID Reader9151017is compatible with cards(only card serial number is read):
ISO14443A (Mifare, DESFire)
PicoPass (HID iClass)
FeliCa
ST SR(IX)
2N
®
Mobile Key
Relay output
Switching contact
30 V / 2 A AC/DC
Active output
9 to 12 V / 700 mA transistor switched output. Depends on power supply (PoE: 9 V or power supply voltage
minus 1 V).
Logical inputs
Active mode – requires external voltage (JP2 jumper OFF)
U
IN
-ON = min +2.5 V
U
IN
-OFF = max +1.5 V
U
IN
max = +48 V
I
IN
(U
IN
+48 V) = max 1 mA
Passive mode – requires external contact only (JP2 jumper ON)
•
Tip
FAQ: Tamper switch – How to install it into the 2N
®
IP Force
