2N IP Force 9151101W - Page 82

Installation manual 2N® IP Force

82 / 118
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
9151031S
Function:
The2N
®
IP ForceInternal RFID Card Reader adds two logical inputs, two
additional switches and a tamperswitch to the2N
®
IP Forcebasic unit.
The purpose of the tamper switch is tosignal any unauthorised opening of
the intercom (to prevent a theft, e.g.).It is recommended to use the tamper
switch.
Specifications:
Card reader
Operating frequency: 13.56 MHz
Minimum reading distance: 30 mm above2N
®
IP Forcecover
RFID card reader 9151031Sis compatible with cards (optionally card serial number or PAC ID is read):
ISO14443A (Mifare, DESFire)
PicoPass (HID iClass)
FeliCa
ST SR(IX)
2N
®
Mobile Key
HID SE (Seos, iClass SE, Mifare SE)
RFID cardreader 9151019is compatible with cards (optionally card serial number or PAC ID is read):
ISO14443A (Mifare, DESFire)
PicoPass (HID iClass)
FeliCa
ST SR(IX)
2N
®
Mobile Key
HID SE (Seos, iClass SE, Mifare SE)
Relay output
Switching contact
30 V / 2 A AC/DC
•
Tip
FAQ: Tamper switch – How to install it into the 2N
®
IP Force
