3Com 4500G - Setting Up the Switch with IP Information

44 CHAPTER 3: SETTING UP FOR MANAGEMENT
Setting Up the Switch with IP Information
You are now ready to manually set up the switch with IP information using
the command line interface.
1 The command line interface login sequence begins as soon as the switch
detects a connection to its console port.
If the login prompt does not begin immediately, press Return a few times
until it starts.
2 At the login and password prompts, enter admin as your user name and
press Return and at the password prompt press Return again. If you have
logged on correctly, <4500G> should be displayed as shown in
Figure 26.
Once you have logged in you will automatically be in User View.
Figure 26 User View Login