3Com 4500G - Tftp

66 CHAPTER 5: UPGRADING SOFTWARE
TFTP To upgrade software to your switch using TFTP do the following:
1 To download the application file, enter:
tftp aaa.aaa.aaa.aaa get s4a03_01_00s168.app
(where aaa.aaa.aaa.aaa is the IP address of the TFTP server) and s4a
indicates the switch filename. see
Tab le 9 for further details.
2 To download the Web user interface file, enter:
tftp aaa.aaa.aaa.aaa get http.zip
3 To download the default configuration file, enter:
tftp aaa.aaa.aaa.aaa get 3ComOScfg.def
4 To download the bootrom file, enter:
tftp aaa.aaa.aaa.aaa get s4e002_012_000.btm
The bootrom firmware may not require upgrading for every software
upgrade, therefore there may not be a new bootrom (.btm) file to
download.
File Distribution
The following commands enable you to distribute your downloaded files to
the remaining switches in the fabric:
1 To copy the new software file to each switch in the fabric, enter:
copy unit1>flash:/s4a03_01_00s168.app unit2>flash:/
Replace unit2 with unit3 and so on for each switch in the fabric.
2 To copy the new default configuration file to each switch in the fabric,
enter:
copy unit1>flash:/3ComOScfg.def unit2>flash:/
Replace unit2 with unit3 and so on for each switch in the fabric.
Table 9 Switch 4500G Filenames
Filename Prefix Switch
s4a Switch 4500G software
s4e Switch 4500G bootrom software