Upgrading from the Command Line Interface 65
3 Any additional files should be considered for deletion to allow maximum
space for downloading the new files. To delete a file from the list enter:
delete/unreserved unit1>flash:/filename
To delete files from the list for the remaining units in a fabric, replace unit1
with unit2 (on the next line) and so on for each switch in the fabric.
4 The /unreserved option will cause the file to be deleted from both the flash
and the recycle-bin. To check that deleted files have been removed from the
recycle-bin enter the following:
reset recycle-bin unit1>flash:/
If the recycle-bin is empty the following is displayed:
% File can’t be found “unitN>flash:/”
To check that deleted files have been removed from the recycle-bin for the
remaining units in a fabric, replace unit1 with unit2 and so on for each
switch in the fabric.
The following steps enable you to backup each switch in the fabric:
1 To back up the default configuration file on each switch in the fabric, enter:
copy unit1>flash:/3ComOScfg.def
unit1>flash:/030100cfg.def
Replace unit1 with unit2 and so on for each switch in the fabric.
2 To back up the active configuration file on each switch in the fabric, enter:
copy unit1>flash:/3ComOScfg.cfg
unit1>flash:/030100cfg.cfg
Replace unit1 with unit2 and so on for each switch in the fabric.
3 To back up the Web user interface file on each switch in the fabric, enter:
copy unit1>flash:/s4h03_01_00.zip
unit1>flash:/030100http.zip
Replace unit1 with unit2 and so on for each switch in the fabric.
To Next Page
Loading...
