68 CHAPTER 5: UPGRADING SOFTWARE
FTP (using a network
port)
To upgrade software to your switch using FTP do the following:
1 Enter the following command from User View:
ftp aaa.aaa.aaa.aaa
(where aaa.aaa.aaa.aaa is the IP address of the FTP server)
If the FTP server has been successfully located, the following information is
displayed:
Trying...
Press CTRL+K to abort
Connected
Information on your FTP server is displayed, logon with your username and
password.
2 To download the configuration file, enter:
get 3ComOScfg.def
The following information is displayed if the download has been successful:
200 PORT command successful.
150 Opening ASCII mode data connection for 3ComOScfg.def(10986
bytes).......226 Transfer complete.
FTP: 10986 byte(s) received in 8.046 second(s) 1000.00
byte(s)/sec.
3 Enter quit to exit.
To Next Page
Loading...
