3Com 9100 - Source Port; Vlan; Verifying Physical and Logical Groupings

106
C
HAPTER
7: Q
UALITY OF
S
ERVICE
(Q
O
S)
Source Port
A source port traffic grouping implies that any traffic sourced from this
physical port uses the indicated QoS profile when the traffic is
transmitted out any other port. To configure a source port traffic
grouping, use the following command:
config ports <portlist> qosprofile <qosname>
In the following example, all traffic sourced from port 7 uses the QoS
profile named
qp3
when being transmitted.
config ports 7 qosprofile qp3
VLAN
A VLAN traffic grouping indicates that all intra-VLAN switched traffic
sourced from the named VLAN uses the indicated QoS profile. To
configure a VLAN traffic grouping, use the following command:
config vlan <name> qosprofile <qosname>
For example, all devices on VLAN
servnet
require use of QoS profile
qp4
for both traffic between devices on
follows
, as well as traffic sourced on
servnet
. The command to configure this example is as follows:
config vlan servnet qosprofile qp4
Verifying Physical and Logical Groupings
To verify settings on port or VLANs, use the command
show qosprofile <qosname>
The same information is also available using the command
show ports info
for ports and
show vlan
for VLANs.