3
A
CCESSING
THE
S
WITCH
This chapter provides the following required information to begin
managing the Switch 9100:
■
Understanding the command syntax
■
Line-editing commands
■
Command history substitution
■
Configuring the switch for management
■
Switch management methods
■
Configuring SNMP
■
Checking basic connectivity
■
Enabling and disabling individual ports
■
Configuring the port speed (100/1000BASE-TX ports only)
■
Configuring half- or full-duplex mode
■
Creating load-sharing groups on multiple ports
For configuration changes to be retained through a power cycle or
reboot, you must issue a SAVE command after you have made the
change. For more information on the SAVE command, refer to
Chapter 10
.
To Next Page
Loading...
