3Com 9100 - Disconnecting a Telnet Session; Disabling Telnet Access

Using Telnet
49
For example:
config iproute add default 123.45.67.1
7
Save your configuration changes so that they will be in effect after the
next switch reboot, by typing
save
For more information on saving configuration changes, refer to
Chapter 10
.
8
When you are finished using the facility, log out of the switch by typing
logout
or
quit
Disconnecting a
Telnet Session
An administrator-level account can disconnect a management session
that has been established by way of a Telnet connection. If this happens,
the user logged in by way of the Telnet connection is notified that the
session has been terminated.
To terminate a Telnet session, follow these steps:
1
Log in to the switch with administrator privileges.
2
Determine the session number of the session you want to terminate by
using the following command:
show session
3
Terminate the session by using the following command:
clear session <session_number>
Disabling Telnet
Access
By default, Telnet services are enabled on the switch. You can choose to
disable Telnet by entering:
disable telnet
To re-enable Telnet on the switch, at the console port enter
enable telnet {access-profile <access_profile> | none} {port
<port_number>}
You must be logged in as an administrator to enable or disable Telnet.