Factory Defaults
23
The rear panel has the following features:
Power Sockets
The Switch 9100 has two, fully redundant, load-sharing power supplies.
Both automatically adjust to the supply voltage. The power supplies
operate down to 90 V. The fuse is suitable for both 110 V AC and
220–240 V AC operation.
Serial Number
The serial number uniquely identifies this unit. You will need this serial
number for fault-reporting purposes.
MAC Address
This label shows the unique Ethernet MAC address assigned to this
device.
Console Port
The console port (9-pin, “D” type connector) is used to connect a
terminal and to carry out local out-of-band management.
Reset Button
The reset button reinitializes the switch. The unit reboots with the last
saved configuration settings.
Factory Defaults
Ta b l e 5 shows the factory defaults for the Switch 9100 features.
Table 5
Switch 9100 Factory Defaults
Item Default Setting
Console port configuration 9600 baud, eight data bits, one stop bit, no
parity, XON/XOFF flow control enabled
Serial or Telnet user account
admin
with no password and
user
with no
password
Web network management Enabled
Virtual LANs One VLAN named
default
; all ports belong to the
default VLAN; the default VLAN belongs to the
STPD named
s0
QoS All traffic is part of a single queue (qp2)
QoS monitoring Automatic roving
(continued)
To Next Page
Loading...
