232 APPENDIX E: 3COM CLI REFERENCE GUIDE
ipSetup The ipSetup command allows the user to define an IP address on the
device either manually or via a DHCP server.
Syntax
ipSetup [dhcp| ip-address mask [default-gateway ip-address]]
Parameters
■ dhcp — Specifies the IP address is acquired automatically from the
Dynamic Host Configuration Protocol (DHCP) server.
■ ip-address mask— Specifies that the IP address and default
gateway are configured manually by the user (Range: 0.0.0.0. -
223.255.255.255).
Default Configuration
No default IP address is defined for interfaces.
User Guidelines
IP Addresses configured beyond the range of 224.0.0.0 are defined as
multicast, experimental or broadcast addresses.
If a default gateway is configured manually, the IP-address and mask are
required to be the same as the gateway-address and mask.
Example
The following example displays an IP address configured manually:
The following example displays an IP address obtained via a DHCP server:
ipSetup 161.71.34.120 255.255.255.0
ipSetup DHCP
To Next Page
Loading...
