3D Prototyping X1 - Printable Accessories Information; Print Platform Leveling

3D Prototyping X1
53
Shown as Figure 7.4.2
figure7.4.2
3. Set the nozzle temperature and platform temperature in the “Control
Panel”->”Temperature”, then click “Set Temp” to start heating. Usually set the nozzle
temperature as 180.0~200.0(PLA) and the platform as 60.0(PLA). If there is material
residue on the print head, please clean it at first.
figure7.4.3
4. Click “platform Leveling ”from “Setting” page. Then “Panel area” will change to
“Control Panel” automatically, and open “platform Leveling” dialog box. Please set the
temperature to be “0” by adjusting “Control Panel”, and clean the spray nozzle to avoid
affecting adjusting leveling.
Screws
Screws（
（（
（b）
））
）
Screws