3D Prototyping X1
54
figure7.4.4
5. Click “ ”from “platform Leveling” dialog box, and move the worktable to the
corner (“bottom left” corner) which corresponding screw “（
（（
（a）
））
）”
6. Click “ ”from “platform Leveling” dialog box to rise the worktable to highest
point. If worktable is too near nozzle, please adjust a little from “Control Panel”. If the
worktable is too far from nozzle, don’t need to adjust, you can set the Z axis height after
the worktable leveling.
7. Click “ ”from “platform Leveling” dialog box and move the worktable to the
corner (“bottom right ”corner) which corresponding screw “(b)”. Then compare the height
of “bottom left” corner (the height between nozzle and worktable, similarly hereinafter) ,
and adjust screw “(b)” to make sure the height is the same as “ bottom left corner”. Click
“ ” and “ ” to check the height difference and adjust to the same
height as nozzle. After finishing, don’t move this two screws any more.
8. Click “ ”from “platform Leveling” dialog box and move the worktable to the
“center of Y axis” position and check the height to adjust screw “(c)” to make sure the
height is the same as we did in last step. Click “ ” and “ ” to check
To Next Page
Loading...