19
24. Select the checkmark to continue.
NOTE: The value presented on the touchscreen
display is the absolute print pad position. Note
and refer to this value when performing the
Manual Level procedure. Your number may differ
from the illustration.
NOTE: If Auto Gap is not successful, it is
recommended that you perform Auto Level
and Auto Gap again. Select AUTO LEVEL to
continue.
NOTE: If Auto Gap is not successful the
second time, select PLATE MAINTENANCE.
For more information, refer to the section titled
PRINT PAD MAINTENANCE. Once the PLATE
MAINTENANCE procedure has been performed,
perform Auto Level and Auto Gap.
NOTE: If Auto Gap is still not successful, select
MANUAL GAP ADJUSTMENT. Refer to the
section titled Manual Gap Adjustment for more
information. Once the Manual Gap Adjustment
has been performed, note the nal reading for
future reference.
To Next Page
Loading...
