Printing the Level Gap Calibration File
NOTE: Ensure the print pad is completely clean from glue and printed parts
before beginning this procedure.
Download the CALIBRATION FILES and extract them to your computer’s hard drive.1.
Navigate to the file location and copy the appropriate file to your USB mass storage2.
device.
Insert the USB mass storage device into the USB host port on the printer.3.
Select PRINT.4.
Using the arrows, navigate to the Level Gap Calibration file and select PRINT.5.
NOTE: There are several Level Gap Calibration files as well as Nozzle Offset
Calibration files. Select the Level Gap Calibration file for print material type
installed in the printer.
To Next Page
Loading...
