4 5
3
EC Declaration of Conformity
Company Name
3M Company
Company Address
Automotive Aftermarket Division
3M Center, Building 251
St Paul, MN USA 55144-1000
Declares that the products:
Product name and or Model number
3M™ Pressure Feed Spray Guns Series 10, 11, 12S, 12SZ, 14, 15, 19, 19C
3M™ Gravity Feed Spray Guns Series 05-100, 05-300, 07, 07HS, 10G, 10GP
Type and/or Description
Pressure Feed and Gravity Feed Spray Guns
Conforms to the following specifi cations:
Directives
Machinery Directive (2006/42/EC) and the essential health and safety requirements
Standards
EN ISO 12100-1:2003 Safety of machinery. Basic concepts, general principles for design
– Basic terminology, methodology
EN ISO 12100-2:2003 Safety of machinery. Basic concepts, general principles for design
–Technical principles
Year in which CE mark fi rst affi xed
2008
Full Name of responsible person.
Kurt Beinlich Position: Technical Director
Signature: Date:
CAUTION
To reduce the risks associated with lifting and handling:
• Always follow proper lifting and handling practices when moving system
components.
To reduce the risks associated with tripping, falling and tipping:
• Route air hoses and any extension cords away from traffi c areas, sharp edges,
moving parts and hot surfaces. Do not pull on air hoses to move the compressor
or turbine unit.
To reduce the risks associated with hazardous air pressure:
• Maintain spray equipment per 3M care and cleaning instructions in the applicable
owner's manual.
• Ensure air input pressure and all applicator system regulators are properly
adjusted prior to each use.
• Always follow required air pressure relief procedures for relieving air pressure
from the unit.
To reduce the risks associated with sharp point:
• If using a turbine unit, do not touch the air hose connection coil relief spring.
To reduce the risks associated with compression spring release:
• Maintain a fi rm grip on fl uid adjustment knob when removing.
To reduce the risks associated with environmental contamination:
• Spray materials, solvents, other cleaning materials and electronic components
must be disposed of per federal, state and local regulations.
To Next Page
Loading...
Need help?
General
