NA - ENG
March 2017
3M-Matic
™
7000a-7000a3 Pro
Page 13
4.1 Power Requirements:
Electrical – 120 VAC, 60 Hz, 6Al, 720W
The machine is equipped with two 1/4 HP gearmotors and comes with an 2.4m [8 foot]
standard neoprene covered power cord and a grounded plug. Contact your 3M Rep-
resentative for power requirements not listed above. Contact your 3M Representative
for power requirements not listed above.
4.2 Operating Rate: Belt speed is 0.5m/s [100 F.P.M.]
Actual production rate is dependent on operator’s dexterity.
Boxes must be 18 inches (457mm) apart minimum.
4.3 Operating Conditions
Use in dry, relatively clean environments at 5
o
C to 50
o
C [40
o
F to 120
o
F] with clean,
dry boxes.
Note: Machine should not be washed or subjected to conditions causing moisture
condensation on components.
4.4 Machine Noise Level:
Acoustic pressure measured at a distance of 1m. from machine with Scotch PVC
adhesive tape in operation; 78dB Acoustic radiation pressure at 1.6m. height with
Scotch PVC adhesive tape in operation; 73dB Measurement taken with
appropriate instrument:(Type SPYRI-MICROPHON 11).
• To reduce the risk associated with re and
explosion hazards:
$ Do not operate this equipment in potentially
ammable or explosive environments.
WARNING
4. Speci cations
To Next Page
Loading...
