3M 3M-Matic 7000r - Tape Roll Diameter; Tape Application Leg Length - Standard; Tape Application Leg Length - Optional; Box Board

15
2014 June
7000r-7000r3 Pro - NA
4-SPECIFICATIONS (continued)
Specifications
4.6 Tape Roll Diameter
Up to 405mm [16 inch] maximum on a 76.2mm [3 inch] diameter core.
(Accommodates all system roll lengths of Scotch
®
fi lm tapes.)
4.7 Tape Application Leg Length – Standard
70mm ± 6 mm [2.75 inch ±. 25 inch ]
Tape Application Leg Length – Optional
50mm ± 6mm [2 inch ±. 25 inch]
(See "Removing Taping Heads Procedure – Changing the Tape Leg Length")
4.8 Box Board
Style – regular slotted containers – RSC
125 to 275 P.S.I. bursting test, single wall or double wall B or C fl ute.
23-44 lbs. per inch of width Edge Crush Test (ECT)
4.9 Box Weight and Size Capacities
A. Box Weight, fi lled: 5 lbs. – 85 lbs. [2.3 kg–38.6 kg]. Contents must support fl aps.
B. Box Dimensions for 7000r Pro and 7000r3 Pro Machines: Inches [mm]
A Standard Pos. B Fully Raised Pos.
Length Width AG 3 Tape Leg
(i.e. 2 3/4" [70])
Minimum 6" [152] 6 1/2" [165]* 4 3/8" [111] 12 1/4" [311]
Maximum N/A 26 1/2" [673] 26" [660] 36" [914]
* Boxes narrower than 8 inches [200mm] may require more frequent belt replacement because of limited
contact area.
To accommodate smaller or larger boxes, machine upper taping head frame and/or outer column assemblies
can be repositioned as described in "Special Set-Up Procedure" section of this manual. Refer to illustration/chart
for box height range possibilities by adjusting machine upper frame and/or outer column positioning.