3M 3M-Matic 8000af - Page 41

North American - ENG
Date Released:
October 2018
3M-Matic
™
8000af - Type 11800
Page 29
44-0009-2153-4 / ECO# 0078045
Figure 11-7 Box Size Setup
Figure 11-6
Place a product  lled box 55 to
65mm [2-1/4 to 2-1/2 inches] into the
exit end of the machine with the top
 aps folded as shown.
Crank the upper head down until it
just contacts the top of the box.
Crank the side drive belts in until the
belts  rmly grip the box.
Figure 11-7
Set Kicker cam relative to length of
box being sealed. Measure the
distance "X" as shown and set the
cam to the same dimension measured
on the box (this dimension provides a
good starting point for setting the
kicker cam).
Note: 5mm hex key wrench is
supplied with machine and
should be kept in wrench
holder on side of upper frame.
Infeed
End
"X"
5mm Hex Key
55 to 65mm
[2 1/4 to 2 1/2 in]
Figure 11-6 Box Size Setup
11. Operation (continued)