3M Attest Auto-reader 490H - Specifications; Power Supply Specifications; Environmental Operating Conditions; Instructions for Use - Initial Set-Up

4 5
1
SPECIFICATIONS
Power SupplySpecifications
Power supply Operating Condition Units
Voltage Range 100‑240 Volts AC
Frequency 50/60 Hertz
Current 0.6 Amps
Environmental OperatingConditions
Environmental Condition Operating Condition Units
Altitude 3000(max) Meters
Operating Temperature 16 – 40 ºC
Storage Temperature ‑10to 50 ºC
Operating Relative Humidity 20‑80(non‑condensing) %
Voltage Range 12 VoltsDC
Frequency DC
Current 1.2 Amps
Installation/Over Voltage CategoryII
Pollution Degree 2
INSTRUCTIONS FOR USE – INITIALSET‑UP
ChooseLocation
Place 3M™ Attest™ Auto‑reader 490H on a firm and level surface, away from sunlight
and incandescent light. To save counter space, units may be stacked twohigh.
WARNING:
• Do not place the instrument in environment exposed to sunlight or strong
incandescentlight.
• Do not place instrument close to any device that emits a strong
electro‑magneticfield.
• Do not use on a vibrating surface.
Select & Install Correct PowerPlug
The 3M™ Attest™ Auto‑reader 490H power supply comes with multiple blade
configurations. Install the blade configuration appropriate for your country into the power
supply and plug into appropriate AC groundedoutlet.
WARNING: Use only the power supply specified for this product and certified for
the country of use.
Wait 30Minutes BeforeUsing
Once plugged in, allow a 30minute warm‑up period before placing 3M™ Attest™ Rapid Readout Biological Indicators 1295into the incubation wells. The C1caution code will
disappear when proper incubation temperature isreached.
SpecialConsiderations
It is recommended that the unit be left on to eliminate warm-up periods. The unit may be turned off when it is anticipated that it will not be used for an extendedperiod.