16
Installation Instructions G5 - Revision C, September 2019
3M™ Drive-Thru System Model G5
To replace the Basestation cover:
• Verify there are no obstructions (tools, etc.) in the way of the cover being closed.
• Align the top edge of the cover with the base.
• Swing the bottom half of the cover down into place and gently push it against the base until it locks into place. Tighten the two
screws located at the bottom of the cover.
Mount the Station
Perform the following procedure to install the Basestation (See Figure 12).
Figure 12.
• Remove the Basestation cover
• Attach the Basestation to the wall using screws and possibly wall anchors.
• The power outlet must be near the equipment and be accessible, and cord placed where it cannot be pinched or bent.
• Due to the many different wall types available, hardware for wall mounting is not included. Secure the product to the wall with
anchors suitable for the wall type, that can support a 4.0lb/1.8kg minimum load.
The steps below assume that all of the communication cabling has been prepared and is available at the Basestation. If not, see “Basestation-
to-Component Wiring” on page 20.
• Follow local best practices and any applicable regulations to route the cables into the Basestation cabinet’s top, sides, or back
(through the wall) as neatly as possible. Do not route power supply wiring with communication wiring in the same conduit.
• Attach all cables to their appropriate terminals.
• Connect the Basestation transformer between the wall outlet and the Basestation power supply connection.
To Next Page
Loading...
