36
Installation Instructions G5 - Revision C, September 2019
3M™ Drive-Thru System Model G5
Change the Night Volume
You can assign a standard reduction in the volume level of the customer order point speaker for night hours when lower volume is typically
required. With the night volume set, the system automatically adjusts the volume during night hours, then back to normal during the day.
To change the night volume setting:
• Enter the configuration mode (see "Enter Configuration Mode" on page 28) and choose 1 System Menu.
• Select a new value for 03 Night Volume > Reduce Drive-Thru Volume At Night By. The range is 0 (no reduction) to the current
day volume level (silent).
Night Volume is never higher than Day Volume.
Night volume reduction is a subtracted value, not the resulting level; therefore, if it is the same as the day volume level,
the speaker will turn off at night.
You cannot change the day outbound talk volume on this screen, only the reduction amount identified above.
Registering Headsets
Each headset must be registered to a Basestation before it can be used.
XT-1 Headsets have a single serial number. This number is imprinted on the headset.
G5 Headsets have 2 serial numbers - one for the G5 Control Pod and the other for the G5 Carrier. The G5 Control Pod serial number is the
primary tracking number for the G5 Headset, and this is the serial number that gets registered on the Basestation. Once registered, it should
not need to be registered again unless it is intentionally removed.
Add Headsets
The procedure below applies to both G5 and XT-1 Headsets. Each headset has a unique serial number. This number is broadcast to the
Basestation whenever the headset signs on.
To register a headset:
• Enter the Basestation configuration mode (see "Enter Configuration Mode" on page 28) and choose 1 System Menu.
• Select 04 Registration > 1 Add New Headsets.
• Power on the headset when prompted.
Or in the case of a G5 Headset, insert the battery to automatically power on the headset.
• Wait up to two minutes for {Headset xxxxxxx Has Been Registered!} to appear at the bottom of the display.
• Repeat the steps above for additional headsets.
• Press Mode when finished.
Alternatively, you may use the Special Short Cut Keys. While on the Run Mode and no fields are selected for editing, the left and right
buttons act as short cut keys to two frequently accessed configuration screens.
Press the left arrow to launch the Add New Headsets screen.
Remove Headsets
Perform the following steps to unregister a lost, destroyed or otherwise removed headset from the system, including a headset that is sent
back to 3M for repair. The headset would have to be registered again at a later date.
• Enter the Basestation configuration mode (see "Enter Configuration Mode" on page 28) and choose 1 System Menu.
• Select 04 Registration > 2 Remove Headsets.
• Scroll to the number of the headset you want to unregister.
• Press Enter.
To Next Page
Loading...
