Installation Instructions G5 - Revision C, September 2019
37
3M™ Drive-Thru System Model G5
Installation Instructions G5
Revision C, September 2019
If you do not know or have access to the number of the headset to be unregistered, identify the headsets that you want to remain in
service and unregister any that remain on the list.
Another method to identify the headset’s serial number without having to disassemble the headset is through the Basestation’s Headset
Setup Menu.
• Enter the Basestation configuration mode (see "Enter Configuration Mode" on page 28) and choose 1 System Menu.
• Select 08 Headset Setup.
• Pay attention to the Serial Number displayed to the right of Currently Editing Headset field.
• Conduct a Page with the operational XT-1 or G5 Headset on hand.
• The Headset Selection field will jump to the headset that is currently paging, which is the headset in your hand.
• Read the serial number off this field.
Figure 26.
This field will only display the last 7 digits of the Headset’s (or G5 Control Pod’s) serial number.
List All Headsets
To see a list of the registered headsets:
• Enter the Basestation configuration mode (see "Enter Configuration Mode" on page 28) and choose 1 System Menu.
• Select 04 Registration > 3 List All Headsets.
Resetting Inactive Days
For any headset, you can manually reset its number of inactive days to zero.
To reset the inactive days:
• Enter the Basestation configuration mode (see "Enter Configuration Mode" on page 28) and choose 1 System Menu.
• Navigate to 08 Headset Setup > Currently Editing Headset.
• Press < or > if necessary to scroll to the headset ID number for the headset you want to reset.
• Select <CLEAR>.
Checking Headset Software Revision
To check the software revision number for a headset:
• Enter the Basestation configuration mode (see "Enter Configuration Mode" on page 28) and choose 1 System Menu.
• Navigate to 08 Headset Setup > Currently Editing Headset.
• Press < or > if necessary to scroll through the headsets. The software version appears below the headset ID number.
Identifying Headset Serial Number
To identify the last 7 digits of a XT-1 Headset or G5 Control Pod) registered to this Basestation:
• Enter the Basestation configuration mode (see "Enter Configuration Mode" on page 28) and choose 1 System Menu.
• Navigate to 08 Headset Setup.
• Pay attention to the serial number displayed in the Headset Selection Field to the right of Currently Editing Headset.
• Conduct a Page with the operational XT-1 or G5 Headset on hand.
• The Headset Selection Field will jump to the headset serial number that is currently paging.
• Read the serial number off this field.
To Next Page
Loading...
