3M LM1 - WIFI SYNCHRONIZATION SETUP DETAILS

15
(English)
EN
4. Turn WiFi on, and select your WiFi network. If it’s a secure WiFi, enter your security credential. Obtain this information
from your IT support.
5. Tap Return
.
6. Tap Settings
.
7. Tap [Preferred Connection - (connection type)]
8. Tap [WiFi]
9. Tap [Web Service Setup].
10. Conrm the Host Name, Common Services Port Number, Device Services Port Number are correct. Obtain this
information from your IT support. If this information is correct, tap OK. If not, use the following instructions to update
this information.
• Tap [Enter Host Name] and use the keyboard to enter the name of your webserver. Obtain this information from your
IT support.
• Or, to nd the name of your webserver for this computer:
a. Click the Windows Start button on the computer.
b. Select Computer
c. Select System Properties
d. The name of your webserver is listed on the screen as Full Computer Name.
e. Tap [Done]
• Tap [Common Services Port Number] and use the keyboard to enter the IIS port number for Common Service Port
No. To nd the Common Services Port No. for the computer that has the Sync Manager Software:
a. Click the Windows Start button on the computer.
b. Click Run….
c. Type inetmgr into the Open: eld then click OK.
d. Expand the computer name in the Connections column.
e. Expand Sites.
f. Click Clean-TraceCommonServices. The Common Services Port No. is the 4 digit number that appears in the
Browse Web Site area in the Actions column. For example, 9003.
g. Tap [Done]
• Tap [Device Services Port Number] and use the keyboard to enter the IIS port number for Device Service Port No.
To nd the Device Services Port No. for the computer that has the Sync Manager Software:
a. Click the Windows Start button on the computer.
b. Click Run….
c. Type inetmgr into the Open: eld then click OK.
d. Expand the computer name in the Connections column.
e. Expand Sites.
f. Click Clean-TraceDeviceServices. The Device Services Port No. is the 4 digit number that appears in the Browse
Web Site area in the Actions column. For example, 9004.
g. Tap [Done].
h. Tap [OK].
• To display the current Web Service information on the 3M Clean-Trace Luminometer without changing it, tap
[Settings]
, then tap [Web Service Setup]. To return to Settings, tap [OK].
• To change the Connection Type to WiFi, refer to the Changing the Connection Type section in this User Manual.
• The 3M Clean-Trace Luminometer WiFi software uses the following ports by default on your computer: 9002, 9003,
9004, 9005. Ensure that these ports are enabled by your antivirus software or rewall.