3M LM1 - Table of Contents

ii
(English)
EN
3
Issue Date: 2016-06
Clean-Trace
™
Luminometer
CONTENTS
INTENDED USE......................................................................... 1
PRODUCT DESCRIPTION ..................................................... 3
Using ATP Detection for Hygiene Monitoring
and Management ...................................................... 3
USING THIS MANUAL ........................................................... 3
OPERATING THE
3M™ CLEAN‑TRACE™ LUMINOMETER ..................... 4
Battery usage and maintenance ..................................... 4
Charging the battery ......................................................... 4
When the battery is charged ........................................... 4
Using the battery level indicator .................................... 4
Managing the battery ...................................................... 4
Switching the Power on .................................................. 4
Switching the Power o ....................................................5
Controlling the Software ...................................................5
Operating Controls of the
3M Clean-Trace Luminometer ................................5
Using the Base .................................................................. 6
Logging in on the 3M Clean-Trace Luminometer ........ 6
Logging in on the 3M Clean-Trace Luminometer
with a PIN ....................................................................7
Waking the 3M Clean-Trace Luminometer
from Sleep Mode ........................................................ 7
Using the Swab Sensor and Vertical
Position Sensor ...........................................................7
Logging out from the
3M Clean-Trace Luminometer .................................7
PERFORMING TESTS ON TEST POINTS WITHIN
SAMPLE PLANS ................................................................ 8
Performing an ATP Test on a Test Point
within a Sample Plan ................................................ 8
Performing a Retest on an ATP Test Point
with a Caution or a Fail Test Status
before Moving to a Dierent Test Point ................ 8
Performing a Retest on an ATP Test Point
with a Caution or a Fail Test Status after
Moving to a Dierent Test Point ............................. 9
Performing a Visual Inspection Test
on a Test Point within a Sample Plan ..................... 9
Recording Temperature or pH for a Test Point
within a Sample Plan ...............................................10
Adding Optional Comments to a Caution
or Fail ATP Test Result ..............................................10
Changing Temperature or pH Recording
for a Test Point within a Sample Plan ....................11
Moving to a Dierent Test Point
in the Same Sample Plan ..........................................11
Moving to a Dierent Test Point
in a Dierent Sample Plan ........................................11
Viewing Test Results ........................................................ 11
Setting Up a Custom Test Type
on a Test Point within a Sample Plan .................... 12
Performing a Retest on a Custom Test Type ................ 12
PERFORMING TESTING ON UNPLANNED
TEST POINTS .................................................................... 13
Performing an Unplanned ATP Test .............................. 13
Performing an Unplanned Visual Inspection Test .......13
SYNCHRONIZING THE 3M CLEAN‑TRACE
LUMINOMETER WITH THE COMPUTER
DATABASE ......................................................................... 14
Setting Up Synchronization
with a USB Connection ..........................................14
Setting Up Synchronization
with a Bluetooth Connection .................................14
Setting Up Synchronization
with a WiFi Connection ..........................................14
Changing the Connection Type .....................................16
Setting Synchronization Time ........................................16
PERFORMING ADMINISTRATIVE TASKS .........................16
Setting the Date and Time on the
3M Clean-Trace Luminometer ...............................16
Performing a Diagnostic Check ..................................... 16
Changing the Screen Brightness ...................................16
Restarting the 3M Clean-Trace Luminometer .............16
Exporting a Log File .........................................................16
Displaying Software Versions ......................................... 17
Troubleshooting ............................................................... 17
APPENDIX ...............................................................................19