3M™ PROTÉGÉ PLUS
PORTABLE MULTI-GAS MONITOR
MAINTENANCE
8006569, Rev. C/June 2019 7-17
7.2.8. ERROR CODES
The following table provides a list of error codes that display on the LCD when applicable.
Table 7-1: Error Codes
Error
Code
Cause Solution
E01
Configuration memory
error
Reset the monitor configuration
E04
Datalog memory is full
Use the PGD software to read the datalog and save the
datalog file. Then delete the datalog through the PGD soft-
ware, refer to PGD software user guide.
E05
Battery depleted
Chargeable battery: charge the battery
un-rechargeable battery: replace the battery
E06
Missing sensor/wrong
sensor installation
Reinstall the sensor or contact the service center
E07
Sensor can not communi-
cate with CO
2
sensor
Re-install sensor module and restart the monitor
E10
G-sensor error Contact the service
E12
ADC full Contact the service
To Next Page
Loading...
