3M PROTEGE PLUS - 6.6. Checking Gas Exposures; 6.7. Configuring Monitor Parameters

3M™ PROTÉGÉ PLUS
PORTABLE MULTI-GAS MONITOR
OPERATION
8006569, Rev. C/June 2018
6-6
6.6. Checking Gas Exposures
After a successful self-test, the detector automatically goes into the Gas Monitoring Mode, in which
the user can view the Peak High, Peak Low, STEL and TWA values.
6.7. Configuring the Monitor Parameters
This section describes the various monitor parameters that are configurable.
The various parameters are shown in Figure 6-3: Monitor Configurable Menu and detailed in Table
6-5: Monitor Configuration Parameters. These parameters allow you to program the individual
monitor to meet your needs.
Table 6-4: Checking Gas Exposure
Action LCD
Press right button during the gas monitoring mode, the peak high
value and low value appear alternatively.
NOTE: The customer can also choose to clear the peak value by
pressing the left button. The device displays “CLEAR PEAK?”, press
the left button to confirm the operation.
Press right button to view STEL alarm set point.
Press right button to view TWA alarm set point.
NOTE: The customer can also choose to clear the peak value by
pressing the left button. The device displays “CLEAR TWA?”, press
the left button to confirm the operation.
Press right button to view the SPAN value.
LEL
CO
PPM
H2S PPM O2
%
%
HIGH
LEL
CO
PPM
H2S PPM O2
%
%
LOW
LEL
CO
PPM
H2S PPM O2
%
%
STEL
LEL
CO
PPM
H2S PPM O2
%
%
TWA
LEL
CO
PPM
H2S PPM O2
%
%