To Next Page

To Previous Page

Operator’s Guide

™

Super Close Projection System SCP716

ENGLISH

D CAUTION

To reduce the risk associated with intense visible light:

Avoid looking directly into the projector lens while the lamp is on.s

To reduce the risk associated with impact of a falling projector:

Use only the 3M brand wall/ceiling mounting hardware kit if wall or ceiling mounting is desired.s

Installation of the 3M brand wall/ceiling kit must only be performed by qualified personnel.s

Adhere strictly to the proper installation procedure as outlined in the installation instructions when s

installing the 3M Wall/Ceiling kit.

Always operate the unit on a flat and sturdy surface.s

To reduce the risk associated with explosion, and/or chemicals from leaking battery:

Use only with battery type AAA.s

Orient the battery’s plus (+) and minus (-) terminals according to the markings found on the remote s

control.

Do not leave the battery in the remote for an extended period of time.s

Do not heat, disassemble, short, recharge, or expose the batteries to fire or high temperature.s

Do not carry batteries loose in your pocket or purse.s

Avoid eye and skin contact in the event that battery would leak.s

Do not mix used and new batteries.s

To reduce the risk associated with tripping, and/or impact:

Position the power cord and cables so that they can not be tripped over.s

To reduce the risk associated with environmental contamination:

Dispose of mercury lamp, exhausted batteries, and other electronic components in accordance with s

applicable federal, state and local regulations.

To reduce the risk associated with hot surface of lamp cartridge:

Before replacing the lamp, allow the lamp to cool for 60 minutes and then unplug the projector s

from the electrical outlet.

To reduce the risk associated with environmental contamination due to mercury:

Hg: Lamp contains mercury. Don’t throw in trash. Dispose according to local, state, or federal laws. s

See www.lamprecycle.org or call 1-800-328-1371.

SAVE THESE INSTRUCTIONS

3M SCP716 User Manual

Other manuals for 3M SCP716