Time and date setting
The Time-Date is used to set-up the current time and date parameters. These settings are used in many of
the charts and graphs in the software and when viewing calibration history and/or time-history measurements
on the instrument.
Setting the Time and Date parameters
1. From the setup screen, select Time-Date by pressing the / keys and press key.
2. To change the Time or Date fields, press the / key to select and press key.
3. Press / arrows to change the values. To move to the next field press / arrows.
4. Press key to save or escape to abort.
• Repeat steps 2 through 4 to change Time and/or Date.
5. To exit the screen, press key. (This will return to the previous screen. To return to the start screen,
press key a second time.)
Figure 3-6: Time and Date Setup screen
To Next Page
Loading...
