3M Versaflo TR-300 PAPR - To Install a Charged Battery Pack; To Remove the Battery Pack

3M™ Versaflo™ Powered and Supplied Air Respiratory Systems
Installin
g
& Removin
g
the Batter
y
Pack
ggy
To install a charged battery pack
 Confirm that the battery pack is fully charged and charge is sufficient for duration
f th k i d
o
f th
e wor
k
per
i
o
d
.
 Hold the unit so the filter cover faces you.
 Inspect the hinge and latch on the battery pack and ensure it is clean and
u
n
da
m
aged
.
u da aged
 Hook the left edge of the battery pack into its holder on the bottom of the unit (1).
 Push the right side of the battery pack into the motor/blower until the latch fully
engages with an audible click (2).
 Grasp the batter
y
pack and
g
entl
y
pull to confirm pack is locked into place.
To remove the battery pack
Hld h i h fil f P h b k l h d ll h
27
© 3M 2011. All Rights Reserved. Rev 1

H
o
ld
t
h
e un
i
t so t
h
e
fil
ter cover
f
aces
y
ou.
P
ress t
h
e
b
atter
y
pac
k l
atc
h
an
d
pu
ll
t
h
e
battery pack down and out.