Step 5. Finishing Up the RAID Controller Installation
www.3ware.com 25
Step 5. Finishing Up the RAID
Controller Installation
After you have installed the controller in the computer and attached
appropriate cables to the controller and drives, complete the
following steps to complete the hardware installation.
Check Installation and Close the Case
1 Verify that the cables do not interfere with the operation of any
other components in the case or block the flow of cooling air.
2 Close the case and reconnect the power cables.
Step 6. Configure Your RAID Arrays
Turn to “First Time RAID Configuration” and “Configuring Units”
in 3ware Serial ATA RAID Controller User Guide for information
about configuring RAID arrays. The user guide is included on the
3ware CD that came with your controller. It is also available from
the 3ware website at
http://3ware.com/support/userdocs.asp.
To Next Page
Loading...
